Sound Advice: Before You Buy a Sub, Let the Room Pick the Spot
I’m shopping for a new subwoofer for the studio. The one I have now is too big for the room, and its processing is a generation behind what current subs can do. Most of the research for the replacement is about the box: driver size, how low it goes, how many watts. That matters less than you’d think. A good sub in the wrong spot will make your low-end decisions worse, not better.
Here’s why. Below about 200 Hz, the room is part of the speaker. Bass waves are long enough to bounce between the walls and stack up. Some frequencies pile up into peaks and others cancel into holes, and both change as you move around the room. Move the sub a couple of feet and the bass at your chair can change by 10 dB or more at some frequencies.
That’s the problem a sub is supposed to solve, so it’s worth setting it up the right way.
Do the sub crawl
The old trick still works, and it costs nothing.
- Put the sub in your chair. Set it at the listening position, roughly where your head would be.
- Play something with steady bass. A bass-heavy track you know well, or pink noise filtered below about 120 Hz.
- Crawl the floor. Move around the spots where the sub could actually live, with your head down near floor level, and listen for where the bass sounds the most even. You’re listening for even, not loud.
- Put the sub there. Swap them back. The spot where the bass sounded even is where the sub goes, because the room works both ways.
Corners will always sound biggest. That’s usually the room boosting a few frequencies, not better bass.
Then set it up
- Pick a crossover. Around 80 Hz is the common starting point. Your monitors handle everything above it, and the sub handles everything below. If your sub or interface can high-pass the mains, do it, so the monitors and the sub aren’t both playing the same bass.
- Check the phase. Play a tone near the crossover point and flip the sub’s phase or polarity switch, or step through its delay setting. Keep whichever setting sounds fullest at your chair. That’s the one where the sub and the monitors are adding together instead of fighting.
- Set the level lower than you want to. Most home studio subs are turned up too loud. The goal is a smooth handoff, not more bass. If kick drums suddenly sound huge on every reference track, back it off.
- Measure if you can. A measurement mic with room correction software, or the free REW (Room EQ Wizard), will show you what your ears can only guess at. Measure after you’ve found the best spot. EQ can trim the peaks, but it can’t fill a hole the room is canceling.
Then check your work
A sub is there to show you what’s happening below the monitors, not to make everything sound bigger. Keep checking mixes the way you did before: with the sub off, on headphones, in the car, and on a phone speaker. If the low end holds up in all of those, the sub is doing its job.
The short version
Don’t pick the spot. Let the room pick it. Crawl the floor, set the crossover and phase, keep the level honest, and measure if you can. Then the sub tells you the truth about the bottom octave instead of lying to you louder.